DSG Advanced Material(Thailand) Co., Ltd.

+66 33 590 290

dsg@dsg-glass.com

Products

DSG ADVANCED MATERIAL(THAILAND) CO., LTD.
Tel: +66 33 590 290
Fax: -
Contact: Mr. Blake Xiong  

Tel: +66 91 802 0608

Email: dsg@dsg-glass.com

Mon-Sat  08.00 - 17.00 pm.
Address: Tiscom Green park Building 1,Tha sa-an, 

Bangpakong, Chachoengsao, Thailand, 24130


Oven glass manufacturer
Oven glass manufacturer
Oven glass manufacturer


Oven glass refers to the abbreviation of special glass used in the oven. Since the oven is a high-temperature operation device, the glass installed on the oven needs to have good heat resistance and mechanical strength.

 

The glass is installed on the oven to facilitate the user to better observe the state of the objects in the oven, in order to adjust the temperature of the oven to control the quality of the objects baked in the oven.

 烤箱玻璃产品效果图二

2 conditions for processing into oven glass

1. It needs to have good mechanical strength and good bending strength;

 

2 , requires high heat resistance temperature, can withstand the long-term baking of high temperature oven without bursting;

 

3 , the softening temperature is relatively high, the softening temperature is high, and the temperature at which the glass can be used is relatively high;

 

4 , good chemical stability, the general oven will often contact a variety of food or other chemicals, the glass can not be reacted. At the same time, it is required that no toxic and harmful objects will be released under high temperature.


烤箱玻璃产品效果图三

Glass products can be below 300 degrees, but can not be water-cooled above 70 degrees, otherwise it will be cold. Fourth, use electric oven glass and precautions 1. New oven glass needs to be cleaned. New oven glass needs to be scrubbed. New oven glass needs to be cleaned before use. Warm water, clean the grill and baking tray.

Then scrub the inside of the oven glass with a soft damp cloth, wait for it to be completely monotonous, then use 2, the new oven glass needs to preheat the oven glass for the first time, you need to preheat the empty box for 5-10 minutes, because the inside of the evaporation box is used for maintenance. The protective film, there may be an odor announced, this is a normal phenomenon, the heating pipe has a layer of maintenance grease attached to the surface, the first time there will be smoke and odor, these conditions will not be seen twice, naturally When baking, you should pay attention to the food that will be dripping with oil. If you need to pick up a dish, if it is not connected, the oil will drop into the heating tube and it will cause smoke and fire. Will not burst out, just smoke

烤箱玻璃产品效果图三